3–13
Chapter 3. Configuring the Printer
Strobe Polarity Standard
IEEE 1284
Parallel Hotport
Trickle Time 1/4 Sec
Timeout 10 Sec.
Report Status Disable
SERIAL INTERFACE
Interface Type RS 232
Data Protocol XON/XOFF
Baud Rate
9600 Baud
Data Bits 8
Stop Bits 1
Parity None
Data Terminal Ready READY and Buffer Not Full
Request to Send True
Buffer Size in Kilobytes 16
Poll Character 00 Hex
One Char Enquiry Disable
Serial Hotport
Trickle Time 1/4 Sec
Timeout 10 Sec.
Report Status Disable
EMULATION CONFIGURATION
IPDS
(2)
Override Host Disable
Graphics Quality Medium
Bar Code Quality High
Image Quality Low
IPDS Emulation Mode 4234
Postnet Barcode Width Standard
UPC/EAN Barcode HRI On
Enhanced Barcode Mode Disable
Compressed Font Disable
Code V Emulation
(2)
SFCC and Power On
Select SFCC 5E
Power on ^X Disable
Power on ^F Disable
Power on ^PY Disable
Lines Per Inch 6
Graphics Options
Slashed Zero Disable
Ignore Dots Value Disable
Append Rotated Disable
Truncate Off Page Alpha Enable
True V
ert 1/10
Disable
Absorb at ^PY Absorb Motion
UPC Descenders Enable
Rotate Character Size Adjusted
Ignore Spaces Disable
Midline PY Disable
Dark Barcode Disable
To Next Page
Loading...
Need help?
General