IBM 6400 Setup Guide

3–20
6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
Saving Your Configuration in a Custom Set
CONFIGURATION
MANAGEMENT
1*
2
3
4
5
6
7
8
Recall
Custom Set
Save Current
Values
Delete
Custom Set
Change
Power On Set
Protect
Custom Sets
Print Custom
Set V alues
* = Factory Default
Once you have changed all of the necessary parameters, it is recommended
you save them as a configuration that can be stored and loaded later for
future use. You can save your configurations to meet different print job
requirements.
The saved configurations (called custom sets) are stored in NVRAM—they
will not be lost if you power off the printer.
Later, you can load one of the configurations for a specific print job. This
eliminates the need to change settings (CPI, LPI, etc.) for each new job. See
page 3–23 about loading configurations.
You may want to print records of your configurations (page 3–8) and store
them in a safe place, such as inside the printer cabinet.
If you do not save your configuration before you power off the printer, all of
the new parameter values that have not been saved to NVRAM will be
erased. When you power the printer on again, the power-on configuration
will load. If no configuration has been designated as the power-on
configuration, the factory configuration will load.
NOTE: To avoid overwriting an existing custom set, the Protect Custom
Sets parameter must be set to ENABLE. See page 4–19 for details.

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English