IBM 6400 Setup Guide

E–4
6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
Code V Feature (VGL)
Configuration
Matching printer operational settings to those of the host computer is known
as printer configuration. The settings, or configuration parameters, such as
selecting the host interface, are adjusted according to the configuration
instructions in Chapter 3, “Configuring the Printer.” Configure the Code V
feature in the same way you would configure the printer for other features.
You can select Code V parameters directly from the operator panel as
explained in this chapter, or by control codes as explained in the
6400 Code V User’s Manual.
Code V Parameters
The Code V parameters are described on the following pages. Parameters
marked with an asterisk (*) indicate the default value. The printer must be
off–line to enter the configuration structure.
Enter and exit the Code V configuration menu according to the steps outlined
in Chapter 3, “Configuring the Printer.” Pressing an invalid key to enter a
parameter value may move you to another level in the configuration or exit
the configuration menu completely.
IMPORTANT
BEFORE you reconfigure the Code V, print a configuration sheet to see
all of the current settings. Refer to Chapter 3, “Configuring the Printer.”
Configure the Code V according to your specific requirements.
The Code V configuration menu is shown in Figure E–1 on the following page.

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English