IBM 6400 Setup Guide

D–14
6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
• Coax Interface => Format Control => Enable
• Coax Interface => Early Print Complete => Enable
Since the host controls are not supported, the printer settings for CPI, LPI,
and others should be set at the printer. See page Setup Guide.
6400–LU0–DSC–Local Non–SNA 3174 Control Unit
LU0–DSC mode is utilized when no host printing controls are required to
accomplish the print function desired and the control unit is attached by a
VTAM–Controlled NON–SNA Control Unit. An existing local 3174
NON–SNA–connected control unit is assumed. The steps required to install
an LU0–DSC printer for host definitions are as follows:
1. Define to VTAM by adding logmode entry to VTAM Logmode
Table
2. Define to JES2 (Not required but recommended. See details
below)
3. Define to CICS or another Application Program such as VPS or
JES328X products.
4. Select the options on the printer that are appropriate for the
environment.
Step 1 – VTAM Definition
The following should be added to the Local Major Node VTAM definition.
The printer will be attached as an LU1–IPDS capable printer.
LOC3174 VBUILD TYPE=LOCAL
LOCPU74 PU CUADDR=nnn...
LOC6400 LU
LOCADDR=n,MODETAB=MYMODETB,DLOGMODE=printer,ISTATUS=AC
TIVE
The following entry should be placed in the VTAM MODE TABLE specified
above or another of your choice.
6400DSCL MODEENTLOGMODE=6400DSCL,
FMPROF=X’02’,TSPROF=X’02’,PRIPROT=X’60’,
SECPROT=X’40’,COMPROT=X’0000’,RUSIZES=X’C7C7’,

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English