D–13
Appendix D. Attaching Host Systems to a Coax/Twinax Printer
Step 2 – VTAM Definition
* The following entry should be placed in the VTAM MODE TABLE
specified above or another of your choice.
6400DSER MODEENTLOGMODE=6400DSER
FMPROF=X’03’,TSPROF=X’03’,PRIPROT=X’B1’,
SECPROT=X’90’,COMPROT=X’3080’,RUSIZES=X’87C6’,
PSERVIC=X’038000000000185018507F00’.
PSNDPAC=X’01’,SRCVPAC=X’01’
Step 3 – JES2 Definition
This definition is not required if you are using VPS and using U1 – U9999 as
the printer ID.
RMT1
LUTYPE3,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,NO
CMPC ,
SETUPHDR,CONSOLE (SETUPHDR=PDIR JES2 V3)
R1.PR1
CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,F,
T/C,P),
CKPTPAGE=30
DESTID NAME=P6400,DEST=R1
Step 4 – Define to CICS or another application program
Refer to the vendor documentation for defining a DSE printer to the program
for its use. Host system commands to change printer settings are not
supported in DSE mode.
Step 5 – Printer Settings
It is recommended that the following printer settings be changed from
factory default settings:
• Printer Control => Interface Selection => Coax
To Next Page
Loading...
Need help?
General