IBM 6400 Setup Guide

D–8
6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
PSERVIC=X’01000000E100000000000000’,
PSNDPAC=X’02’,SRCVPAC=X’02’,SSNDPAC=X’00’
Step 2 – JES2 Definition (SYS1.PARMLIB)
RMT1
LUTYPE1,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,NOCM
PCT,
SETUPHDR,CONSOLE
R1.PR1
CLASS=A,NOSEP,PRWIDTH=132,NOFCBLOD,WS=(W,R,Q,PMD,LIM,F,
T/C,P),
CKTPAGE=30
DESTID NAME=LOC6400,DEST=R1
Step 3 – Define to CICS or another application program
An application program must provide the SCS commands to control the
printer. CICS, VPS, and other applications support SCS as well as numerous
application programs, both customer written and vendor supplied. Refer to
the vendor documentation for defining an SCS printer to the program for its
use. If there is no specific information on the 6400 you may use the IBM
4234 for reference.
Step 4 – Printer Settings
It is recommended that the following printer settings be changed from
factory default settings:
• Printer Control => Interface Selection => Coax
• Coax Interface => Format Control => Enable
6400–LU1–SCS–Remote SNA 3174 Control Unit
LU1–SCS mode is utilized when neither IPDS nor PSF is needed to
accomplish the print function desired. An existing remote 3174
SNA–connected control unit is assumed. The steps required to install a
remote LU1–SCS printer for host definitions are as follows:

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English