4–19
Chapter 4. Configuration Menus
Save Current Values
This option allows you to save your custom sets to meet different print job
requirements. This eliminates the need to change the parameter settings for
each new job.
The custom sets are stored in NVRAM—they will not be lost if you power
off the printer.
Factory default is a factory-preset custom set; it cannot be changed or saved.
IMPORTANT
A new custom set will overwrite an existing custom set if the PROTECT
CUSTOM SETS parameter is disabled (e.g., a new Custom Set 4 will
overwrite an existing Custom Set 4). See the “Protect Custom Sets” in
this section.
Delete Custom Set
You can delete one or all of your customized or preloaded custom sets. Factory
default is a factory-preset custom set and cannot be changed or deleted.
Change Power On Set
You can specify which of the custom sets will be the power–on custom set.
The printer will power on with the factory set values or with one of the
customized configurations.
Protect Custom Sets
The PROTECT CUSTOM SETS option specifies whether or not a new
custom set can overwrite an existing custom set when you activate the SAVE
CURRENT VALUES parameter.
• DISABLE (the default) turns protection off, allowing you to overwrite
existing custom sets.
• ENABLE turns protection on, preventing you from overwriting existing
custom sets. If you attempt to save to an existing set, the following
operator panel message appears:
043 CUSTOM SET ALREADY EXISTS
DELETE FIRST
You must delete the existing set before trying to save the new custom set.
Print Custom Set Values
This option is used to print a listing of various stored printer custom sets. It is
recommended that you store the printout of the custom sets in a safe place for
quick referral.
To Next Page
Loading...
Need help?
General