4–29
Chapter 4. Configuration Menus
Coax Interface Menu
Print
Language
Print
Character
Table
(2)
(From page 4–9)
COAX
INTERFACE
(3)
See page
4–30.
T
o exit the configuration menus
T
o view options, press:
T
o select an option, press:
*
= Factory Default
and return to READY
, press:
Enter ReturnScroll Scroll
Start
Enter
T
o exit the configuration menus
Disable*
Enable
Disable*
Enable
Active Print
Language
Standard Print Language*
Alternate Print Language
Note:
(1)
In coax mode, the options for P
A1, P
A2, and Buf
fer Reprint are
displayed only when the coax line is active.
(2)
Does not apply to IPDS.
(3)
The T
winax and Coax interface menus only appear in the
menus if the IBM Coax/T
winax feature is installed. If the
Multi–Platform Interface Coax/Twinax feature is installed
the T
winax and Coax Interface menus are not displayed
because the feature does not use these menus.
PA1
(1)
PA2
(1)
Buffer
(1)
Reprint
Disable*
Enable
Port T
ype
T
winax* – Coax – Disable
Timeout
10 Sec–180 Sec (15 Sec*)
Report Status
Disable* – Enable
Lead–In Characters
Set 1 <%>*
Set 2
$
Set 3 _%_
Alternate Set 80– 9F
Control Code
Printable*
Cancel
Buffers
Hex
Transparent
Control
Printer
Emulation
4234*
3287
Enable*
Disable
Mono/Dual
Case
Undefined
Character
Substitution
40–FE (HEX)
60*
Dual Case*
Mono Case
Intervention
Required
Control By Host*
Left to Right
Right to Left
Send to Host*
Not Send to Host
Compatibility
Options
Default*
Downloaded
Override
Host
See page
4–38
Override
Host
Disable*
Enable
Translate
Table
Early Print
Complete
Disable*
Enable
C/T Hotport
Disable*
Enable
Hex Print
Mode
(2)
Format
Control
Disable*
Enable
Print T
ext
Direction
Image Buf
fer
Size
4K*
2K
13.2 inches*
13.6 inches
Maximum
Printable Width
Figure 4–6. Coax Interface Menu
To Next Page
Loading...
Need help?
General