IBM 6400 Setup Guide

4–32
6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
PA2
PA2 is only valid when the printer is in the NOT READY state and the coax
SCS data stream is active. This function displays the “PA2 ENABLED”
message when the Enter key is pressed and sends a special operator request
to the host when the printer is made READY.
NOTE: Selecting the PA2 menu item again (“PA2 DISABLED” appears on
the operator panel) or selecting the PA1 menu item will reset the
pending PA2 function.
Buffer Reprint
This option is only valid when the printer is in the NOT READY state and
the Coax SCS data stream is active. The printer displays the “ENABLED”
message when the Enter key is pressed, and sends an Intervention Required
Status to the host when the printer goes to READY state.
NOTE: Selecting the Buffer Reprint menu item again (“DISABLED”
appears on the operator panel) will reset the Buffer Reprint function.
Printer Emulation
This parameter defines the printer emulation, as follows:
• 4234 (the default)
• 3287
After the emulation has been changed, a POR status is sent to the host.
Early Print Complete
Early Print Complete capability allows the printer to send Print Complete
status to the host before the printer is actually done printing all data.
• DISABLE (the default) means the printer will suppress the Early Print
Complete response until all printing is complete.

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English