IBM 6400 Setup Guide

4–89
Chapter 4. Configuration Menus
Margins
NOTE: LEFT MARGIN and RIGHT MARGIN selections are not available
with the Coax/Twinax emulation. The only variable available with
the Coax/Twinax emulation is BOTTOM MARGIN.
The MARGINS parameter defines where the bottom, left, and right page
margins are located.
• LEFT MARGIN defines where print position 1 is located. The left
margin is specified as the number of characters from the left edge of the
forms. Valid values range from 0 through 369 characters. The default is 0
characters.
• RIGHT MARGIN defines where the last print position is located. The
right margin is specified as the number of characters from the right edge
of the forms. Valid values range from 0 through 369 characters. The
default is 0 characters.
• BOTTOM MARGIN defines the location of the last print line on the
page. The bottom margin is specified as the number of lines from the
bottom of forms position. Valid values range from 0 through 451 lines.
The default is 0 lines.
Perforation Skip
NOTE: The PERFORATION SKIP selection is not available with the
Coax/Twinax emulation.
Perforation Skip allows or prevents printing on page perforation. When
enabled, it sets up a skip-over margin of 1/2 inch, 2/3 inch, 5/6 inch, or 1
inch. For example, a skip-over margin of 1 inch allows a 1 inch margin at the
bottom of the page perforation.
Reset Command
Reset Command specifies the configuration that will be used by the printer
after the reset command is issued.
• Load Factory will load the factory default configuration for printer use.
This is the default selection.
• Load Power On will load the selected power on configuration for printer
use.

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English