IBM 6400 Setup Guide

3–25
Chapter 3. Configuring the Printer
Changing the Power On Configuration
CONFIGURATION
MANAGEMENT
Factory
Default*
Custom Set 1
Custom Set 2
Custom Set 3
Custom Set 4
Custom/Preloaded Set 5
Custom/Preloaded Set 6
Custom/Preloaded Set 7
Custom/Preloaded Set 8
Recall
Custom Set
Save Current
Values
Delete
Custom Set
Change Power
On Set
Protect
Custom Sets
Print Custom
Set V alues
* = Factory Default
When you power on the printer for the first time, it loads the factory default
configuration. If you power the printer off and then back on, the printer will
load the designated power-on configuration (which is set to Factory Default
by default). It will not load the last saved configuration.
The Change Power On Set option allows you to select a custom set of
configuration values as the power–on configuration. The example on the
following page shows how to select Custom Set 1 as the power-on
configuration.
NOTE: Be sure you define and save a custom set before attempting to use it
as the Power On Custom Set. Otherwise, the current Power On
Custom Set remains selected and the following operator panel
message is displayed:
042 CUSTOM SET DOES NOT EXIST
SAVE FIRST
For example, if you attempt to change the Power On Custom Set from
Custom Set 1 to Custom Set 4, and if Custom Set 4 does not exist,
Custom Set 1 remains the Power On Custom Set.

IBM 6400 Specifications

General

Brand	IBM
Model	6400
Category	Printer
Language	English