IBM 6400

4–87
Chapter 4. Configuration Menus
NOTE: Receipt of a data stream control code which changes the forms
length overrides the forms length previously specified via the
operator panel.
Print Quality
NOTE: When using bold or emphasized printing, the printer prints two dots
instead of one to produce the desired effect. This does not affect
characters per inch.
This parameter specifies the density (quality) of printing:
• DP Quality (the default)
• Near Letter Quality
• OCR A
• OCR B
• Draft
• NLQ Sans Serif
NOTE: Receipt of a data stream control sequence that changes the print
quality overrides the print quality specified via the operator panel.
Specifying a print quality of OCR A or OCR B will change the print
language to OCR A or OCR B.
When OCR A or OCR B is selected as the default print language,
OCR A/OCR B are the only available values for this parameter. If a different
print quality value is desired, the print language must be changed first.
Print Character Table
This parameter prints out a table of the current interface character set.