4–69
Chapter 4. Configuration Menus
Character Sets
This parameter selects a character set for the P–Series emulation. Once you
have selected a character set, you must also define a print language for that
character set, described under the PRINT LANGUAGE option.
• IBM PC (the default)
• MULTINATIONAL
• ECMA LATIN 1
• DEC MULTINATIONAL
• OCR A
• OCR B
• 0858 PC EURO MULTILINGUAL
• 0923 LATIN 9 8859–15
NOTE: See the 6400 ASCII Programmer’s Reference Manual for information on
character sets.
Print Language
If you selected one of the character sets other than OCR A/OCR B, 0858, or
0923 (which have only one available print language), you must also select a
print language for that character set. The print languages available for each
character set are shown in Figure 4–18 on page 4–68. The default print
language for each character set follows:
• IBM PC: Default for Select Subset Primary is
ASCII (USA).
Default for Select Subset Extended is
0437 PC Character Set.
• MULTINATIONAL: Default is ASCII (USA).
• ECMA LATIN 1: Default for Select Subset Primary is
ASCII (USA).
Default for Select Subset Extended is
MULTINATIONAL.
• DEC MULTINATIONAL: Default is ASCII (USA).
To Next Page
Loading...
Need help?
General