5–12
6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
Dataproducts Parallel Interface Configuration
Your printer is configured at the factory to match the interface you specified.
By using the operator panel, you may verify and change several interface
parameters in order to meet specific application requirements.
Refer to Chapter 4, “Configuration Menus,” for Dataproducts parameter
descriptions and information on selecting values for the following
parameters:
• Data Bit 8 (enable or disable)
• PI Ignored (enable or disable)
• Data Polarity (standard or inverted)
• Data Request Polarity (standard or inverted)
• Strobe Polarity (standard or inverted)
Some application programs require a unique configuration. If the printer is
not working properly in the configuration you have selected, contact an IBM
service representative.
To Next Page
Loading...
Need help?
General