D–12
6400 Line Matrix Printers Setup Guide, Cabinet and Pedestal Models
Step 4 – Printer Settings
It is recommended that the following printer settings be changed from
factory default settings:
• Printer Control => Interface Selection => Coax
• Coax Interface => Format Control => Enable
• Coax Interface => Early Print Complete => Enable
In LU3 mode the printer settings control the orientation, CPI, LPI and all
other aspects of the printed output. Therefore, you must set the printer
settings to match the characteristics of the job you are printing. Host controls
are not supported in this mode.
6400–LU3–DSE–Remote SNA 3174 Control Unit
LU1–DSE mode is utilized when host controls are not needed to accomplish
the print function desired. An existing remote 3174 SNA–connected control
unit is assumed. The steps required to install an LU1–DSE printer for host
definitions are as follows:
1. Define to (NCP point to LU1 default logmode entry defined
below)
2. Define to VTAM by adding logmode entry to VTAM Logmode
Table
3. Define to JES2 (May not required if VPS. See details below)
4. Define to JES328X Print Facility, VPS, or equivalent product.
5. Select the options on the printer that are appropriate for the
environment.
Step 1 – NCP Definition
XYZ GROUP TYPE=NCP,...
LINK ADRESS=(032),...
PU ADDR=C1,...
&luname LU LOCADDR=#, (# replaced by port on control unit)
DLOGMOD=6400DSEL,(Default LOGMODE ENTRY
NAME)
MODETAB=MYTABLE (Table name containing
MODEENT)*
To Next Page
Loading...
Need help?
General