D–9
Appendix D. Attaching Host Systems to a Coax/Twinax Printer
1. Define to NCP, point to LU1 logmode entry defined below
2. Define to VTAM by adding logmode entry to VTAM Logmode
Table
3. Define to JES2 (May not required if VPS. See details below)
4. Define to JES328X Print Facility, VPS, or equivalent product.
5. Select the options on the printer that are appropriate for the
environment.
Step 1 – NCP Definition
XYZ GROUP TYPE=NCP,...
LINK ADRESS=(032),...
REMPU74 PU ADDR=C1,...
REM6400 LU LOCADDR=#,(# replaced by port on control unit)
DLOGMOD=6400SCSR,(Default LOGMODE ENTRY NAME)
MODETAB=MYTABLE (Table name containing MODEENT)*
Step 2 – VTAM Definition
* The following entry should be placed in the VTAM MODE TABLE
specified above or another of your choice.
6400SCSR MODEENT LOGMODE=6400SCSR,
FMPROF=X’03’,TSPROF=X’03’,PRIPROT=X’B1’,
SECPROT=X’90’,COMPROT=X’3080’,RUSIZES=X’87C6’,
PSERVIC=X’01000000E100000000000000’,
PSNDPAC=X’01’,SRCVPAC=X’01’
Step 3 – JES2 Definition
This definition is not required if you are using VPS and using U1 – U9999 as
the printer ID.
RMT1
LUTYPE1,BUFSIZE=3840,LINE=1,NUMRD=0,NUMPR=1,NOCOMP,NOCM
PCT,
To Next Page
Loading...
