E–9
Appendix E. Code V, IGP, and IPDS Menus
Ignore Spaces
• Disable. The default. Trailing spaces are NOT deleted from
alphanumeric elements in a graphics pass.
• Enable. Trailing spaces are deleted from alphanumeric elements in a
graphics pass.
Midline PY
• Enable. Allows printable characters to precede the ^PY command.
• Disable. The default. Requires the ^PY command to be the first
characters on a line.
Dark Barcode
• Disable. The default. Bar codes are printed in normal mode.
• Enable. When enabled, prints all bar codes in a dark mode.
Expanded Font
• Scalable: The default. These expanded characters have rounded edges.
• Block: These are block characters compatible with the IGP–X00
printers.
Width Limit
• Disable. The default. This does not limit the width of expanded
characters.
• Enable. When enabled, limits the width of expanded characters based on
a fixed maximum ratio of width over height.
Absorb at ^PN
• Disable. The default. When disabled, system terminators following the
(cc)PN command are sent to the printer and result in paper motion.
• Enable. Prevents paper motion following the (cc)PN command.
IGP110 Compatibility
• Enable. The Default. This menu will process ^IPEXP commands in the
same manner the IGP does, and does not expand special font characters
if an ^IPEXP command precedes it.
To Next Page
Loading...
