3–5
Chapter 3. Configuring the Printer
Parallel
Configuration Twinax
Interface
Coax
Page
4–17
Page 4–20
Page 4–29
Print
Language
Print Character T
able
(4)
Active Print Language
Printer Emulation
Printer Address
W
orld T
rade
Cancel Buf
fers
Early Print Complete
(2)
Hex T
ransparent Control
Undefined Character
Reporting
Undefined Character
Substitution
Load Alternate Character
Option
Print T
ext Direction
Override Host
Format Control
Hex Print Mode
(4)
C/T Hotport
Print Language
Print Character T
able
(4)
Active Print Language
PA1
PA2
Buf
fer Reprint
Printer Emulation
Early Print Complete
Cancel Buf
fers
Hex T
ransparent Control
Mono/Dual Case
Undefined Character
Substitution
Print T
ext Direction
Image Buf
fer Size
Intervention Required
Compatibility Options
T
ranslate T
able
Override Host
Format Control
C/T Hotport
Hex Print Mode
(4)
Page
4–45
Interface
T
ype
PC Parallel
Dataproducts
IEEE 1284
Ethernet
(3)
Parallel Hotport
Management
Printer
Page
4–10
Interface
Selection
Display Language
Alarm Control
Print Direction
Hex Print Mode
Power On State
Paper Jam Detection
Forms Speed
Set Platen at Bottom
of Form
Shuttle T
imeout
Energy Saver T
imer
OCR Font Density
Eject/Restore
PTR Setup Option
File System
Power Stacker
(3)
Control
Recall Custom Set
Save Current V
alues
Delete Custom Set
Change Power On Set
Protect Custom Sets
Print Custom Set V
alues
Emulation Operator
Print Tests
Printer
Information
Page
4–58
Page 4–90
Page 4–92
Configuration
Serial
Page 4–53
IPDS
(3)
Code
V Emulation
(3)
IGP Emulation
(3)
ASCII Printer
Emulation
Printer Emulation
Configuration
Print Format
Printer Demonstration
Print Error Log
Ripple Print
All E’
s
All H’
s
All E’
s + FF
Underlines
Ethernet T
est Page
Installed Memory
Power On T
ime:
Printing T
ime:
Print Strokes
1
1 Inch Pages
Interface T
ype
Data Protocol
Baud Rate
Data Bits
Stop Bits
Parity
Data T
erminal Ready
Request to Send
Buf
fer Size in Kilobytes
Poll Character
One Char Enquiry
Serial Hotport
Interface
Interface
Interface
T
o exit the configuration menus
T
o view options, press:
T
o select an option, press:
*
= Factory Default
and return to READY
, press:
Enter ReturnScroll Scroll
Start
Enter
T
o exit the configuration menus
(1)
(1)
RibbonMinder
New Ribbon
Ribbon Action
Ribbon Size
Ribbon Adjust
Fault Action
Notes:
(1)
The T
winax and Coax interface menus only appear in the menus if the IBM
Coax/Twinax
feature is installed. If the Multi–Platform Interface Coax/T
winax feature
is
installed the T
winax and Coax Interface menus are not displayed because the
Multi–Platform Interface feature does not use these menus.
(2)
The
Early Print Complete option appears in the T
winax menu only if
the IPDS feature
is
installed.
(3)
Options
appear in the menus only if these features are installed. Menus are
shown
in
Appendix E.
(4)
Not available in IPDS.
Page
7–3
Figure 3–1. Configuration Main Menu
To Next Page
Loading...
Need help?
General