IDEC SmartRelay Manual
89
Programming IDEC SmartRelay
3.7 riting and starting the circuit program
3.7.13 Setting the power-on delay of IDEC SmartRelay
ou can set a power-on delay for IDEC SmartRelay in order to make sure all the connected
expansion modules are powered on and ready to use before IDEC SmartRelay runs the
circuit programs.
To set the power-on delay, follow these steps:
1. In the programming menu, move the cursor to
: Press or
2. Confirm
: Press O.
3. Move the cursor to
: Press or
4. Confirm : Press O. IDEC SmartRelay shows the following display:
5. Press or to increase or decrease the delay time by 0.2 s. ou can also press and hold
down or to uickly increase or decrease the time.
6. Confirm your setting: Press O
.
3.7.14 Clearing the circuit program and password
To clear a circuit program and the password if one is defined, follow these steps:
1. Switch the IDEC SmartRelay to programming mode. IDEC SmartRelay opens the main
menu:
1HWZRUN
'LDJQRVWLFV
To Next Page
Loading...
Need help?
General
