Configuring IDEC SmartRelay
8.1 Selecting parameter assignment mode
IDEC SmartRelay Manual
256
If no parameter can be set, the display shows as follows, and you can press ESC to return
to the parameter assignment menu.
5. Press or to move the cursor to the block that you desire to change its parameter, and
confirm with O
.
6. Now, select the desired parameter: Press or
7. Select the parameter you want to edit, and press O
.
8.1.3 Modifying parameters
ou first Selecting the parameters (Page 255).
ou change the value of the parameter in the same way as you did in programming mode:
1. Move the cursor to the point at which you want to make the change: Press or
2. To change this value: Press or
3. To apply the value: O
Note
hen changing the time parameter when the system is in RUN, you can also change the
timebase (sseconds, mminutes, hhours). This does not apply if the time parameter
represents the result of another function (for an example, see the On-delay (Page 132)
topic). In this case you can neither change the value nor the timebase. The current time is
reset to zero when you change the timebase.
1RSDUDPHWHU
(UURU
%
7 V
7D V
%ORFNQXPEHU
'LVSOD\QXPEHUIRUIXQFWLRQVZLWK
VHYHUDOGLVSOD\V
7KHFXUUHQWWLPHLQ,'(&6PDUW5HOD\
7KHYDOXHVHWDWSDUDPHWHU77LPH
%
7D V
7 V
Ⴑ
Ⴇ
Ⴃ
Ⴍ
To Next Page
Loading...
Need help?
General
