Programming IDEC SmartRelay
3.8 Configuring additional functions for IDEC SmartRelay
IDEC SmartRelay Manual
96
Transferring the circuit program to WindLGC
After you have finished the network settings, you can transfer the circuit program from IDEC
SmartRelay to WindLGC using the transfer command IDEC SmartRelay → PC in WindLGC.
For further information on uploading the circuit program to WindLGC with this transfer menu
command, refer to the Online Help for WindLGC.
3.8.2 Configuring a UDF (User-Defined Function)
You can configure UDF (User-Defined Function) blocks only from WindLGC.
A UDF block is a preconfigured circuit program that you create in WindLGC. You can add it to
an existing circuit program as you do with a function block. For a detailed description of the
UDF configuration in WindLGC, refer to the Online Help for WindLGC.
If your circuit program in IDEC SmartRelay contains a UDF block, you can configure elements
connected to the block. For more information of configuration of UDF elements from IDEC
SmartRelay, refer to the topic UDF (User-Defined Function) (Page 247).
3.8.3 Configuring the Data Log
You can configure the Data Log block only from WindLGC.
You can configure a maximum of one Data Log for your circuit program using WindLGC. The
Data Log is used to record process measurement variables of the selected function blocks.
For a detailed description of configuration of the Data Log function in WindLGC, refer to the
Online Help for WindLGC.
If your circuit program in IDEC SmartRelay contains the Data Log block, you can configure
elements connected to the block. For more information of configuration of Data Log elements
from IDEC SmartRelay, refer to the topic Data log (Page 251).
To Next Page
Loading...
Need help?
General
