IDEC SMARTRELAY User Manual

IDEC SmartRelay functions
4.4 Special functions list - SF
IDEC SmartRelay Manual
146
Setting the Par parameter
View in programming mode (example):
View in parameter assignment mode (example):
4.4.7 Asynchronous pulse generator
Short description
ou can asynchronously output pulses with this function.
Parameters TH and TL
Note the information on parameter T in topic Time response (Page 124)
The actual value of another already-programmed function can provide the pulse width TH and
the interpulse width TL. ou can use the actual values of the following functions:
 Analog comparator (Page 183)(actual value Ax  Ay)
 Analog trigger (Page 178)(actual value Ax)
 Analog amplifier (Page 191)(actual value Ax)
 Analog multiplexer (Page 209)(actual value A)
Symbol in
IDEC SmartRelay
iring Description
Input En ou can use input EN to set and reset the
asynchronous pulse generator.
Input Inv ou can use input Inv to invert the output signal of the
active asynchronous pulse generator.
Parameter ou can configure the pulse width T
H
and the
interpulse width T
L
.
Retentivity:
/  No retentivity
R  The status is retentive.
Output  The pulse and pause values cyclically set and reset .
3URWHFWLRQPRGHDQGUHWHQWLYLW\
3XOVHZLGWK
,QWHUSXOVHZLGWK
1XPEHURISXOVHSDXVHF\FOHVH[DPSOH
7/ V
7+ V
%5
1R 
&XUUHQWSXOVHZLGWK7
/
RU7
+
7D V
7/ V
7+ V
%
4
(Q
,QY
3DU
$V\QF3XOVH
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

IDEC SMARTRELAY Specifications

General

Brand	IDEC
Model	SMARTRELAY
Category	Other
Language	English