IDEC SmartRelay software
11.2 Connecting IDEC SmartRelay to a PC
IDEC SmartRelay Manual
280
11.2 Connecting IDEC SmartRelay to a PC
Connecting IDEC SmartRelay to a PC
IDEC SmartRelay has an Ethernet port so you can connect a Base Module to a PC with an
Ethernet cable.
Switching IDEC SmartRelay to PC IDEC SmartRelay mode
Two methods are available to switch IDEC SmartRelay to STOP mode:
Switch IDEC SmartRelay to STOP mode from your PC (refer to the Online Help for
indLGC).
Select the following menu command on a device with display.
Confirm your selection with
:
hen IDEC SmartRelay is in STOP mode and online with the PC, the following PC
commands are available:
Switch IDEC SmartRelay to RUN
Read/write the circuit program
Read/write the summertime/wintertime
Closing the PC IDEC SmartRelay mode
hen IDEC SmartRelay completes the data transfer, it shuts down the connection to the PC.
N
ote
For more information on IDEC SmartRelay versions without display, refer to the Appendix
topic IDEC SmartRelay without display (IDEC SmartRelay Pure) (Page 305).
N
ote
If you have password-protected the program that you created in indLGC, IDEC
SmartRelay receives both the circuit program and the password during the download.
The upload of a password-protected program created in IDEC SmartRelay is possible only
after you enter the correct password in indLGC.
6WRS
3URJUDP
6HWXS
1HWZRUN
'LDJQRVWLFV
6WRSSURJUDP"
<HV
1R
To Next Page
Loading...
Need help?
General
