IDEC SMARTRELAY

Configuring IDEC SmartRelay
8.2 Setting the default values for IDEC SmartRelay
IDEC SmartRelay Manual
258
Current value of a freuency trigger
View of the parameter of a freuency trigger in parameter assignment mode:
ou can change the on/off threshold.
8.2 Setting the default values for IDEC SmartRelay
ou can set the following default values for a Base Module:
Clock settings
ou can set the default values for Setting the time of day and date (Page 259), and
Summertime/wintertime conversion (Page 90) in programming mode or parameter
assignment mode through the following menu commands:
Contrast and backlight settings
ou can set the Setting the display contrast and backlight choice (Page 261) and the Setting
the display contrast and backlight choice (Page 261) in programming mode or parameter
assignment mode through the following menu commands:
Menu language
ou can Setting the menu language (Page 263) in which IDEC SmartRelay displays the
menus in programming mode through the following menu commands:
Number of Base Module analog inputs
The Base Modules FL1F-H12SCD, FL1F-H12RCE, and FL1F-B12RCE support four analog
inputs. Formerly they supported two. ou can choose whether to Setting the number of AIs in
IDEC SmartRelay (Page 264) on these modules in programming mode through the following
menu commands:
%
2Q
2II
ID




2IIWKUHVKROG
2QWKUHVKROG
3URFHVVYDULDEOH
6HWXS &ORFN
2.
6HWXS
2.
/&'
6HWXS
0HQX/DQJXDJH
2.
%0$,180
6HWXS
2.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com