IDEC SmartRelay Manual
63
Programming IDEC SmartRelay
3.7 riting and starting the circuit program
3.7 riting and starting the circuit program
The example below shows how to create a program for your circuit design in IDEC
SmartRelay.
3.7.1 Selecting programming mode
hen you connect IDEC SmartRelay to the power supply and switch it on, the display shows
you the main menu of the programming mode:
The first line is highlighted. Press and to move the highlight bar up and down. Move it to
and confirm with O. IDEC SmartRelay opens the programming menu.
The I
DEC SmartRelays programming menu is as shown below:
Here you can also move the highlight bar by pressing and . Move the highlight bar to
and confirm with O.
ou are now in the circuit program window. Press O
to enter the program editing mode, and
the cursor appears as a solid suare at the NE block. The display now shows as follows:
Confirm with O
and IDEC SmartRelay now shows you the first output:
ou are now in programming mode. Press and to select the other outputs. Now you can
start to edit your circuit program.
1HWZRUN
'LDJQRVWLFV
To Next Page
Loading...
Need help?
General
