IDEC SMARTRELAY

IDEC SmartRelay Manual
235
IDEC SmartRelay functions
4.4 Special functions list - SF
4.4.36 Average value
Short description
The average value function calculates the average value of an analog input over a configured
time period.
Symbol in
IDEC SmartRelay
iring Description
En A change in status from 0 to 1 transition at input En
starts the average value function.
A change in status from 1 to 0 at input En holds the
analog output value.
R A signal at input R clears the analog output value.
Ax Input Ax is one of the following analog signals:
 AI1 to AI8 ()
 AM1 to AM64
 NAI1 to NAI32
 A1 to A8
 NA1 to NA16
 Block number of a function with analog output
Parameter St (Sampling time): you can set the timebase to s
(seconds), d (days), h (hours), or m (minutes).
Range of values:
St  s: 1 to 59
St  d: 1 to 365
St  h: 1 to 23
St  m: 1 to 59
Sn (Number of samples):
Range of values:
St  s: 1 to St100
St  d: 1 to 32767
St  h: 1 to 32767
St  m and St  5 minutes: 1 to St6000
St  m and St  6 minutes: 1 to 32767
Retentivity:
/  no retentivity
R  retentivity
Output A Outputs the average value of input Ax over configured
time sampling period.
 AI1 to AI8: 0 V to 10 V corresponds with 0 to 1000 (internal value).
$4
$[
(Q
5
$[
3D
U
$YHUDJH9DOXH
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com