IDEC SMARTRELAY

IDEC SmartRelay Manual
193
IDEC SmartRelay functions
4.4 Special functions list - SF
4.4.23 Latching relay
Short description
Input S sets output , input R resets output  again.
Timing diagram
Switching response
A latching relay represents a simple binary element. The output value depends on the status
at the inputs and on the previous output status. The following table shows the logic once
again:
hen retentivity is enabled, the current status of the output signal is retained after a power
failure.
Symbol in
IDEC SmartRelay
iring Description
Input S ou set output  with a signal at input S.
Input R ou reset output  with a signal at input R. If S and R
 1, the output is reset.
Parameter Retentivity:
/  no retentivity
R  the status is retentive.
Output   is set with a signal at input S, and reset with a signal
at input R.
S
n
R
n
 Comment
0 0 x The status is retentive
0 1 0 Reset
1 0 1 Set
1 1 0 Reset (takes priority over Set)
56
4
6
5
/DWFKLQJ5HOD\
3DU
4
5
6
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com