IDEC SmartRelay Manual
59
Programming IDEC SmartRelay
3.5 Configuring menu access protection for IDEC SmartRelay
3.5 Configuring menu access protection for IDEC SmartRelay
IDEC SmartRelay provides two access levels, administrator and operator, to limit access to
specific menus in programming mode. As an administrator, you can access all menu
commands while as an operator, some specific menu commands are not visible (see section
Overview of IDEC SmartRelay menus (Page 61)). IDEC SmartRelays default setting is
administrator at delivery, and you can switch to operator at any time. hen switching from
operator to administrator, you need to enter a valid password (IDEC by default). IDEC
SmartRelay always saves its access level before power-off.
Switching IDEC SmartRelay from administrator to operator
To switch IDEC SmartRelays access level from administrator to operator, follow these steps:
1. Move the cursor to
on the main menu of programming mode: Press or
2. Confirm : Press O
3. Move the cursor to
: Press or
4. Confirm
: Press O
IDEC SmartRelay now switches to the access level of operator and returns to the main menu.
N
ote
The access level of the Text Display is operator by default, and you can switch it to
administrator with the password IDEC.
The Text Display saves its access level before power-off if it connects to the same Base
Module after power-on. If you connect a different Base Module to it, however, the Text
Display restores its access level to operator after power-on.
The access level setting on the Text Display is independent of that on the Base Module.
1HWZRUN
'LDJQRVWLFV
To Next Page
Need help?
General
