IDEC SmartRelay Manual
95
Programming IDEC SmartRelay
3.8 Configuring additional functions for IDEC SmartRelay
Configuring the network settings
IDEC SmartRelay provides a menu command for configuring network settings.
1. Switch IDEC SmartRelay to programming mode.
2. Press or to move the cursor to
.
3. Press O to confirm .
4. Press or to move the cursor to
.
5. Press O
to confirm
. IDEC SmartRelay displays the following view:
6. The display now shows the default IP address of your IDEC SmartRelay. To change the
setting, press O
. hen the cursor appears in a flashing solid suare, press or to
move the cursor to a position where you want to modify the number, then press or to
increase or decrease the number. To confirm your change, press O
.
IDEC SmartRelay stores up to four addresses that you set previously. To view your last
settings, press to move the cursor to the symbol, and then press O
to open a drop-
down list, for example:
ou can press or to select a previously configured address in the list, and then press
O
to comfirm.
7. Press or to move to the subnet mask setting. The default subnet mask is as shown
above. To change the setting, press O
. hen the cursor appears in a flashing solid
suare, press or to move the cursor to a position where you want to modify the
number, then press or to increase or decrease the number. To confirm your change,
press O
.
8. Press to move to the gateway address setting. The default gateway is as shown above.
To change the setting, press O
. hen the cursor appears in a flashing solid suare,
press or to move the cursor to a position where you want to modify the number, then
press or to increase or decrease the number. To confirm your change, press O
.
'LDJQRVWLFV
To Next Page
Loading...
Need help?
General
