IDEC SMARTRELAY User Manual

Configuring IDEC SmartRelay
8.2 Setting the default values for IDEC SmartRelay
IDEC SmartRelay Manual
262
Setting the backlight choice in parameter assignment mode
Follow these steps to set the backlight choice:
1. On the parameter assignment menu, move the cursor to 
 : Press or
2. Confirm 
 : Press O
3. Move the cursor to 
 : Press or
4. Confirm 
 : Press O
5. Move the cursor to 
 : Press or
6. Confirm 
 : Press O
7. Move the cursor to 
  or   : Press or
8. Confirm 
  or   : Press O
The default setting is that the backlight is not on. To set the backlight to always be on,
select 
 .
Setting the backlight choice in programming mode
If you want to set the backlight in programming mode, select menu command    in the
main menu, then menus 
  and   . ou can now set the backlight as described earlier.
N
ote
The backlight lifetime of the Text Display is 20000 hours.
ou can change the backlight colors of the IDEC SmartRelay onboard display or the FL1F-
RD1 by means of some special markers (M25, M26, M28 to M31). For more information,
refer to section Constants and connectors (Page 111). If you use these special markers in
your circuit programs, the backlight setting through the above menu commands takes no
effect.
1HWZRUN
'LDJQRVWLFV
6WRS

3URJUDP
6HWXS
0HQX/DQJXDJH
6ZLWFKWR23
0VJ&RQILJ

6WDUW6FUHHQ
&ORFN
/&'
&RQWUDVW

%DFNOLJKW
%DFNOLJKW
'HIDXOW
$OZD\V2Q


Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com

IDEC SMARTRELAY Specifications

General

Brand	IDEC
Model	SMARTRELAY
Category	Other
Language	English