Janus JFS-A1 - Notification Appliance Circuits (Nacs); NAC Wiring; NAC Wiring Configurations

Page: 94
JFS-A1 INSTALLATION, OPERATION, AND INSTRUCTION MANUAL
Document #: DOC230
Issued: August 27, 2012
Revised: N/A
NoticationApplianceCircuits(NACs)
ere are six (6) NAC circuits provided on the PSN-1000/PSN-1000(E) rated as continuous 3 amps at 24 VDC.
e NAC circuits may be congured for Class A or Class B. (Please refer to the Class A and B wiring examples shown in
this section.) e circuits reverse polarity upon activation and are marked accordingly on the board and illustrations.
NAC Wiring
• Outputs are supervised and regulated.
• NAC circuits are power limited.
• Type of NAC output is selectable, and may be congured for strobe synchronization with Potter/AMSECO,
Wheelock®, Gentex®, or System Sensor® strobe devices. Please refer to Potter document “5403592 NAC
Compatibility Document” for this information.
• Class-A operation is accomplished by using a pair of NAC circuits (NAC 1&2, NAC 3&4 and NAC 5&6); this
pairing provides three (3) Class A circuits, each rated for a continuous 3 amps at 24 VDC.
NAC Maximum Impedance Formula
e maximum impedance is a function of the load being applied to the circuit. In order to calculate the maximum
impedance as follows:
(Alarm Current of Notication Appliances) x (Wire Resistance) < 3 Volts
NACWiringCongurations
Examples of Class A and B follow.
Figure 119. Class B NAC Wiring Example
Notes:
1. e Potter part number for the listed end of line assembly is #3005013 EOL Resistor Assembly.
2. e panel has ground fault detection on the NAC circuits. e impedance to ground for ground fault detection is 0 ohms.
- I1 + - NAC 1 + - NAC 5 + - NAC 3 +
- + A B
5.1k EOL
Potter Part #3005013
Notification
Appliance
- I2 + - NAC 2 + - NAC 4 + - NAC 6 +
-
+ A B
P-LINK
DWG #602-24