Page: 41
JFS-A1 INSTALLATION, OPERATION, AND INSTRUCTION MANUAL
Document # : DOC230
Issued: August 27, 2012
Revised: N/A
Programming Overview
e LEARN function is available through the control panel, and is an ecient way to automatically congure all
system devices. LEARN detects all connected devices, assigns a name and selects the applicable device type (i.e.,
module, sensor or P-Link device). e system conguration mirrors a basic re protection system where all inputs and
outputs are a one-to-one relationship.
e panel conguration software allows custom programming and conguration for all points via a network or
remote computer. At the click of a mouse, you may ne-tune device behavior characteristics or create mapping
zones for a more sophisticated re protection system. By using the system software, you will realize the power and
exibility of the JFS-A1 system. (Please refer to “Panel Software Overview” and “Mapping Zones” in this section for
details on these procedures.)
The Programming Cycle
e following is a recommended approach to programming the system:
1. Install Software
2. Address and Install SLCs
3. Run LEARN
4. Connect Ethernet Cable
5. Upload Data to Computer
6. Program the System
7. Download Conguration File
Note: is approach may eliminate programming errors, however, these are only recommendations.
Software Installation
It's easy to install the JFS-A1 software and requires only a few minutes to complete. Once done, the program
automatically creates a shortcut icon on your desktop for easy access.
e system software is compatible with Windows XP, Windows Vista and Windows 7 Operating Systems, and
incorporates conventional shortcuts and features (i.e., right click to display short cut menus, drag and drop, etc.). e
software’s exibility enables you to eectively program individual and/or groups of devices. Several examples in
conguring a basic re system are provided later in this section under the “System Programming” heading.
Note: e latest version of Microsoft .NET Framework is required.
To install the software:
y Access the Potter website at www.pottersignal.com, and go to the "Fire Alarm Systems" link, then click the "Fire
Panel Conguration Software" icon to select program to download.
y e default installation directory is: C:\ProgramFiles\Potter\Potter Fire Panel Programmer.
y You may change the location of the application les.
To Next Page