Janus JFS-A1 - SLC Functions

Page: 73
JFS-A1 INSTALLATION, OPERATION, AND INSTRUCTION MANUAL
Document # : DOC230
Issued: August 27, 2012
Revised: N/A
SLC Functions
e SLC conguration options are described in the table below:
Table 20: SLCCongurationFunctions
Function Description
Unused SLC point is unused.
Addr Detector Photo Photoelectric Sensor (PSA)
Addr Detector Photo Heat Combination Photo-Heat Sensor (PSHA)
Addr Detector Heat Fixed Fixed Temperature Heat Detector (FHA)
Addr Detector Heat Combo Combination Fixed Temperature and Rate-of-Rise Heat Detector (RHA)
Addr Relay General Purpose Addressable Relay Module (TRM)
Addr NAC General Purpose Monitored Output Module (MOM)
Addr Zone Module Two-Wire Conventional Detector Module (CIZM)
Addr Sounder Base Addressable Sounder Base (ASB)
Addr Relay Base Addressable Relay Base (ARB)
Contact Input Pull Station
Dry contact input options used with MCM, SCM or DCM modules; available
for on-board I/O circuits.
Note: When using an input module on an abort function, there is a 6-second
delay before panel responds.
Contact Input Water Flow
Contact Input Supervisory
Contact Input Tamper
Contact Input Fire Drill
Contact Input Trouble Monitor
Contact Input Aux
Contact Input Abort (see note)
Contact Input Reset
Contact Input Silence