Janus JFS-A1 - PSN-1000;PSN-1000(E) Operations; Status Leds

Page: 100
JFS-A1 INSTALLATION, OPERATION, AND INSTRUCTION MANUAL
Document #: DOC230
Issued: August 27, 2012
Revised: N/A
PSN-1000/PSN-1000(E)Operations
e PSN-1000/PSN-1000(E) operates as a fully integrated power expander. e input circuits and/or NAC circuits
are congured in the same manner as any input circuit or NAC circuit in the system. Circuit functions and zone
assignments are dened using the system software.
Status LEDs
e PSN-1000/PSN-1000(E)'s status LEDs communicate system conditions by illuminating and/or ashing the
applicable green or amber indicators. ese are described in the table shown below.
Table 24: PSN-1000/PSN-1000(E)StatusLEDs
LED Type LED Color/Action Description
AC Power Steady Green ON = AC present; OFF = AC not present
Low Battery
Steady/ Flashes
Amber
OFF = No Fault; Flashing = Low Battery conditions
ON = Battery Charger Failure
Note: The PSN-1000 transfers from AC to battery instantly upon AC failure or
brownout. The trouble relay on the panel will indicate the low AC condition after the
Low AC Report Delay has elapsed.
Earth Fault Flashing Amber Indicates that an earth fault is detected.
Comm. 1 Flash Green Flash indicates successful communication with the NAC control board.
Bulk Comm. Flashing Green Flash indicates successful communication with the bulk supply board.
RPTR Comm. Flashing Green Indicates when P-Link repeater communications are occurring.
Main Comm. Flashing Green Flash indicates when P-Link commands are received from the control panel.