Janus JFS-A1 - P-Link Accessories; SLC Loop Accessories; Addressable Sensors

Page: 2
JFS-A1 INSTALLATION, OPERATION, AND INSTRUCTION MANUAL
Document #: DOC230
Issued: August 27, 2012
Revised: N/A
 Support for all major synchronization patterns.
 Potter
 Gentex®
 CooperWheelock®
 System Sensor®
 Built-in Ethernet port for programming and network connectivity.
 Built-in e-mail support to communicate system status and event information.
 P-Link RS-485 bus supports system accessories.
 1,000 event non-volatile history buer.
 Learn mode enrolls connected sensors and modules for ecient system programming.
 99 Software Zones
 Dead-front Cabinet Design
 2 X 16 character LCD display
 Dedicated Alarm, Supervisory and Trouble Form C Relays
 Analog / Addressable Sensing Technology
 Drift Compensation
 Maintenance Alert
 NFPA 72 compliant calibrated smoke test built-in
P-Link Accessories
 RA-6500R or RA-6075R Remote Annunciator – Maximum of 31 per system in any combination
 UD-1000 Dual Line Fire Communicator – Maximum of 1 per system
 CA-6075 Class A converter module – Maximum of 1 per system allows for ClassA wiring of the SLC circuit,
P-Link communication bus and the two (2)built-in NAC circuits
 PSN-1000 / PSN-1000(E) Intelligent Power Supply Expander – An accessory to the panel providing ten (10)
amps of additional power, with six (6) notication circuits
SLC Loop Accessories
• Addressable Sensors
 Photoelectric Smoke Detector (PSA)
 Photoelectric/Heat Smoke Detector (PSHA)
 Fixed Temperature Heat Detector (FHA)
 Rate of Rise/Fixed Temperature Heat Detector (RHA)
 Addressable Isolator Base (AIB)
 Addressable Relay Base (ARB)
 Addressable Sounder Base (ASB)