Janus JFS-A1 - Page 115

Page: 105
JFS-A1 INSTALLATION, OPERATION, AND INSTRUCTION MANUAL
Document # : DOC230
Issued: August 27, 2012
Revised: N/A
Figure 135. Example of Primary Account Settings "Expanded" Window
Notes:
– Use the scroll bar to display additional elds if not shown on right.
– Click the
collapse icon at any time to hide the account setting elds.
 Enter the Account ID.
 Select the applicable Primary Format option: CID / SIA
 Click in the Report Test Events selection box to send Test signals to this account.
 Double-click in the Receiver IP eld and enter the IP address provided by the remote monitoring station.
 Click on the Protocol drop-down arrow to select Fibro.
Note: Fibro communications is used with the Sur-Guard receiver.
 Double-click in the UDP port eld to enter the Primary/Secondary port number as provided by the remote
monitoring station.
Note: e UDP port number is the pathway for data which the receiver receives from the system panel and
sends to the system panel.
 Double-click in the Supervision Interval eld to adjust the amount of time (in seconds) that the panel's IP
Communicator will send a supervision signal to the remote monitoring receiver.
– Default setting is 20 seconds.
– Contact the remote monitoring station to verify the correct setting. e receiver is programmed with a
specic window of time to "see" the supervision signal. If the supervision signal is not seen within the
programmed time, the receiver generates a Trouble signal after six (6) failed communication attempts.
 Double-click in Encryption Key to enter an applicable number as provided by the remote monitoring
station.
 Click on the Encryption Method drop-down arrow to select 128 bit, if applicable.
Note: If the Encryption Method is set to "None", then an Encryption Key is not needed.
5. Click on the collapse icon to hide the account setting eld when nished.
Reminder: Click the expand ellipsis icon to review or modify the account settings at any time.
6. Repeat steps for each Primary / Secondary reporting account or to edit an account.
Click here to collapse
additional elds.