Page: ix
JFS-A1 INSTALLATION, OPERATION, AND INSTRUCTION MANUAL
Document # : DOC230
Issued: August 27, 2012
Revised: N/A
Preface
This manual is intended for use with the Janus Fire Systems® JFS-A1 Releasing Control Panel. Those who install,
operate, program, or service this panel should read this entire manual.
All design, implementation, and maintenance of the Janus Fire Systems® JFS-A1 Releasing Control Panel must
be performed in compliance with the National Fire Protection Association (NFPA) 70 - The National Electrical
Code, NFPA 2001 - Standard on Clean Agent Fire Extinguishing Systems, NFPA 12 - Standard on Carbon Dioxide
Extinguishing Systems, NFPA 13 - Standard for the Installation of Sprinkler Systems, NFPA 16 - Standard for the
Installation of Foam-Water Sprinkler and Foam-Water Spray Systems, NFPA 72 - The National Fire Alarm Code,
and the guidelines outlined in this manual.
Janus Fire Systems® reserves the right to revise and improve its products as it deems necessary without prior
notication. This manual describes the state of Janus Fire Systems® products at the time of its publication and may
not reect those products at all times in the future.
All references to Codes or Standards in this manual refer to the latest edition of that Code or Standard unless
otherwise indicated.
The contents of this manual may not be reproduced in any form without the express written consent of Janus Fire
Systems.
Copyright © 2012 Janus Fire Systems. All Rights Reserved. Janus Fire Systems® is a registered trademark of Janus Fire Systems.
Janus Fire Systems
1102 Rupcich Drive
Millennium Park
Crown Point, IN 46307
TEL: (219) 663-1600 FAX: (219) 663-4562
e-mail: info@janusresystems.com · www.janusresystems.com
To Next Page
Loading...