114 VARIABLE SPEED DRIVE SERIES III LIT-12012999—June 2018 www.johnsoncontrols.com
Chapter 7—Advanced application parameter
Table 170. Basic Setting — P7.1, continued
Code Parameter Min. Max. Unit Default ID Note
P7.1.5
PID1 Process Unit Min -99999.99 See Par ID 1300 Varies 0.00 1298
P7.1.6
PID1 Process Unit Max See Par ID 1298 99999.99 Varies 100.00 1300
P7.1.7
PID1 Process Unit Decimal 0 4 2 1302
P7.1.8
PID1 Error Inversion 0 1303 See Par ID 181
P7.1.9
PID1 Dead Band 0.00 99999.99 Varies 0.00 1304
P7.1.10
PID1 Dead Band Delay 0.00 320.00 s 0.00 1306
P7.1.11
PID1 Ramp Time 0.00 300.00 s 0.00 1311
Table 171. Monitor — P7.2
Code Parameter Min. Max. Unit Default ID Note
P7.2.1 FB PID1 Set Point 1 See Par ID 1298 See Par ID 1300 Varies 2542
P7.2.2 FB PID1 Set Point 2 See Par ID 1298 See Par ID 1300 Varies 2544
P7.2.3 FB PID1 Feedback 1 % 2550
P7.2.4 FB PID1 Feedback 2 % 2551
P7.2.5 FB PID1 Feedforward 1 % 2554
P7.2.6 FB PID1 Feedforward 2 % 2555
Setpoint
Table 172. Basic — P7.3.1
Code Parameter Min. Max. Unit Default ID Note
P7.3.1.1
PID1 Keypad Set Point 1 See Par ID 1298 See Par ID 1300 Varies 0.00 1307
P7.3.1.2
PID1 Keypad Set Point 2 See Par ID 1298 See Par ID 1300 Varies 0.00 1309
P7.3.1.3
PID1 Wake Up Action 0 2466 0 = Below Wake Up Level
1 = Above Wake Up Level
2 = Below Wake Up Level(PID
ref.) Wake up when below
wakeup level % set in
Para ID 1318 or 1327 from
PID Setpoint.
3 = Above Wake Up Level
(PID ref.) Wake up when
above wakeup level % set
in Para ID 1318 or 1327
from PID Setpoint.
Note:
Parameter value can only be changed after the drive has stopped.
Parameter value will be set to be default when changing macros.
To Next Page
Loading...
Need help?
General
