Table 56: Port Edit Options (continued)
Your ActionFunctionField
Select one of the following values: 10 Mbps, 100 Mbps,
1000 Mbps, or Auto-Negotiation.
NOTE: EX4300 switches support Auto-Negotiation
10M-100M apart from the values mentioned above.
Specifies the speed for the mode.Speed
Select one: automatic, half, or full.
NOTE:
•
For EX4300 switches’ link-mode setting, see
Configuring Gigabit Ethernet Interfaces (CLI
Procedure).
Specifies the link mode.Duplex
Enter a brief description for the link.Describes the link.
NOTE: If the interface is part of a link aggregation
group (LAG), only the Description option is enabled.
Other Port Edit options are unavailable.
Description
Select the check box to enable autonegotiation, or
clear the check box to disable it. By default,
autonegotiation is enabled.
Enables or disables autonegotiation.Enable Auto
Negotiation
Select the check box to enable flow control to regulate
the amount of traffic sent out of the interface, or clear
the check box to disable flow control and permit
unrestricted traffic. Flow control is enabled by default.
Enables or disables flow control.Enable Flow
Control
Select the check box to enable the media type. Then
select Copper or Fiber.
Specifies the media type selected.Media Type
IP Options
1. Select the IPv4 address check box to specify an
IPv4 address.
2. Type an IP address—for example: 10.10.10.10.
3. Enter the subnet mask or address prefix. For
example, 24 bits represents 255.255.255.0.
4. Click OK.
Specifies an IPv4 address for the interface.
NOTE: If the IPv4 Address check box is cleared, the
interface still belongs to the inet family.
IPv4 Address
Copyright © 2017, Juniper Networks, Inc.114
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1
To Next Page
Loading...
