Table 56: Port Edit Options (continued)
Your ActionFunctionField
1. For this port role, you can select a VLAN member
and associate a native VLAN with the interface.
2. Click Details to view CLI commands for this role.
3. Click OK.
Applies the Layer 2 uplink role.
The interface family is set to ethernet-switching, port
mode is set to trunk, RSTP is enabled with the
point-to-point option, and trusted DHCP is configured
for port security.
Layer 2 Uplink
Specifies that no port role is configured for the
selected interface.
None
NOTE: For an EX8200 switch, dynamic ARP inspection and DHCP snooping parameters are not configured.
VLAN Options
If you select Trunk, you can:
1. Click Add to add a VLAN member.
2. Select the VLAN and click OK.
3. (Optional) Associate a native VLAN with the
interface.
4. Click OK.
If you select Access, you can:
1. Select the VLAN member to be associated with the
interface.
2. (Optional) Associate a VoIP VLAN with the
interface. Only a VLAN with a VLAN ID can be
associated as a VoIP VLAN.
NOTE: VoIP is not supported on EX8200 switches.
3. Click OK.
Specifies the mode of operation for the interface:
trunk or access.
Port Mode
Link Options
Type a value from 256 through 9216. The default MTU
size for Gigabit Ethernet interfaces is 1514.
Specifies the maximum transmission unit size (MTU)
for the interface.
MTU (bytes)
113Copyright © 2017, Juniper Networks, Inc.
Chapter 9: Interfaces
To Next Page
Loading...
