Table 64: FPC PoE Settings (continued)
Your ActionDescriptionField
By default, the power management
mode is class. Select static to change
the power management mode.
Specifies the power management mode. The options are static
and class.
NOTE: When the power management mode is set to class, the
maximum power value is overridden by the maximum power value
for the interface that is connected to the switch on the PoE port.
When the power management mode is set to static, you can specify
the maximum power for each PoE interface.
PoEManagement
Enter a value to set the guard band
value in watts. The default value is 0.
Specifies the amount of power reserved for power spikes from the
PoE power budget of the switch.
Guard Band
(watts)
Select a value in watts.Specifies the maximum PoE wattage available to provision active
PoE ports on the FPC. For example, if you specify 1000 W, the PoE
controller is limited to a power budget of 1000 W to distribute to
the PoE ports.
Maximum Power
Release History Table DescriptionRelease
J-Web Application package Release 14.1X53-A2 does not support
Power over Ethernet (PoE) on EX4600 switches.
14.1X53-A2
Related
Documentation
• Configuring PoE on EX Series Switches (CLI Procedure)
• Example: Configuring PoE Interfaces on an EX Series Switch
• Example: Configuring PoE Interfaces with Different Priorities on an EX Series Switch
• Example: Configuring PoE on an EX6200 or EX8200 Switch
• Monitoring PoE on page 200
• Understanding PoE on EX Series Switches
Copyright © 2017, Juniper Networks, Inc.122
J-Web Application Package User Guide for EX Series Switches, Release 14.1X53-A1
To Next Page
Loading...
Need help?
General
