Table 101: Ethernet Switching Output Fields (continued)
ValueField
MAC Learning Log or Interface Information
The name of the Interface.Interface Name
NOTE: This option is supported only on EX4300
switches.
The VLAN name.VLAN-Name
The VLAN ID.VLAN ID
NOTE: This option is supported only on EX4300
switches.
The learned MAC address associated with the VLAN ID.MAC Address
NOTE: This option is not supported on EX4300
switches.
Maximum number of MAC addresses.MAC Limit
NOTE: This option is supported only on EX4300
switches.
The state of the STP interface. Values are Discarding or Receiving.STP State
NOTE: This option is supported only on EX4300
switches.
Specifies the logical interface flags. The flag options are:
• DL - disable learning
• AD - packet action drop
• LH - MAC limit hit
• DN - interface down
Flags
NOTE: This option is supported only on EX4300
switches.
States whether the VLAN associated with interface is tagged or untagged.Tagging
NOTE: This option is supported only on EX4300
switches.
Time at which the MAC address was added or deleted from the MAC
learning log.
Time
NOTE: This option is not supported on EX4300
switches.
Operating state of the interface. Values are Up or Down.State
NOTE: This option is not supported on EX4300
switches.
219Copyright © 2017, Juniper Networks, Inc.
Chapter 16: Monitoring Tasks
To Next Page
Loading...
