Table 102: Summary of IGMP Snooping Output Fields (continued)
ValuesField
Learning domain for snooping.Learning Domain
NOTE: This option is supported only on EX4300 switches.
Frequency (in seconds) with which the router sends
membership queries when it is the querier.
Query Interval
NOTE: This option is supported only on EX4300 switches.
Time (in seconds) that the router waits for a response to a
general query.
Query Response Interval
NOTE: This option is supported only on EX4300 switches.
Time (in seconds) that the router waits for a report in response
to a group-specific query.
Last Member Query Interval
NOTE: This option is supported only on EX4300 switches.
Number of times the router retries a query.Robustness Count
NOTE: This option is supported only on EX4300 switches.
Specifies the multicast router.MRouters
NOTE: This option is not supported on EX4300 switches.
Specifies the multicast receiver.Receivers
NOTE: This option is not supported on EX4300 switches.
Interface Details
Name of the interface.Interfaces
NOTE: This option is only supported on EX4300 switches.
Operating state of the interface. Values are Up or Down.State
NOTE: This option is only supported on EX4300 switches.
Number of groups on the interface.Group count
NOTE: This option is only supported on EX4300 switches.
State of immediate leave. Values are On or Off.Immediate Leave
NOTE: This option is only supported on EX4300 switches.
Router interfaces that are part of this learning domain.Router Interface
NOTE: This option is only supported on EX4300 switches.
IGMP Route Information
221Copyright © 2017, Juniper Networks, Inc.
Chapter 16: Monitoring Tasks
To Next Page
Loading...
