Juniper EX3200 Hardware Guide

The fan tray, uplink module, and transceivers are hot-removable and hot-insertable: You
can remove and replace them without powering off the switch or disrupting switch
functions.
To install a power supply in an EX3200 switch, follow instructions in “Installing a Power
Supply in an EX3200 Switch” on page 191. To remove a power supply from an EX3200
switch, follow instructions in “Removing a Power Supply from an EX3200 Switch” on
page 192.
To install a fan tray in an EX3200 switch, follow instructions in “Installing a Fan Tray in
an EX3200 Switch” on page 187. To remove a fan tray from an EX3200 switch, follow
instructions in “Removing a Fan Tray from an EX3200 Switch” on page 188.
To install an uplink module in an EX3200 switch, follow instructions in “Installing an
Uplink Module in an EX3200 Switch” on page 195. To remove an uplink module from an
EX3200 switch, follow instructions in “Removing an Uplink Module from an EX3200
Switch” on page 197.
To install an SFP, SFP+, or XFP transceiver in an EX3200 switch, follow instructions in
“Installing a Transceiver” on page 201. To remove an SFP, SFP+, or XFP transceiver from
an EX3200 switch, follow instructions in “Removing a Transceiver” on page 203.
Related
Documentation
• Cooling System and Airflow in an EX3200 Switch on page 27
• Power Supply in EX3200 Switches on page 29
• Uplink Modules in EX3200 Switches on page 15
• Pluggable Transceivers Supported on EX3200 Switches on page 75
153Copyright © 2016, Juniper Networks, Inc.
Chapter 11: Installing the Switch

Juniper EX3200 Specifications

General

Model	EX3200
Rack Units	1U
Layer Support	Layer 2 and Layer 3
Junos OS	Yes
Maximum VLANs	4093
DRAM	512 MB
Flash Memory	256 MB
Ports	24 or 48
Uplink Ports	4 SFP
Power Supply	AC or DC
MAC Address Table Size	16, 000 entries
Dimensions (W x D x H)	17.4 x 14.4 x 1.7 inches
Weight	12.3 lb (5.6 kg)
Operating Temperature	0°C to 40°C
Operating Humidity	10% to 85% (non-condensing)