Juniper EX3200 Hardware Guide

Table 43: Optical Interface Support for Gigabit Ethernet XFP Transceivers in EX3200
Switches (continued)
ValueSpecificationEthernet Standard
EX-XFP-10GE-ZRModel number10GBASE-ZR
10 GbpsRate
LCConnector type
DualFiber count
1550 nmTransmitter wavelength
0Minimum launch power
4 dBmMaximum launch power
–30 dBmMinimum receiver sensitivity
–7 dBmMaximum input power
SMFFiber type
9/125 µmCore/Cladding size
–Modal bandwidth
80 km (49.7 miles)Distance
AvailableDOM support
Junos OS for EX Series switches, Release 9.0 or laterSoftware required
Related
Documentation
Uplink Modules in EX3200 Switches on page 15•
• Installing a Transceiver on page 201
• Removing a Transceiver on page 203
Pluggable Transceivers Supported on EX Series Switches
The transceivers for EX Series switches are hot-removable and hot-insertable
field-replaceable units (FRUs): You can remove and replace them without powering off
the switch or disrupting switch functions.
109Copyright © 2016, Juniper Networks, Inc.
Chapter 8: Transceiver and Cable Specifications

Juniper EX3200 Specifications

General

Model	EX3200
Rack Units	1U
Layer Support	Layer 2 and Layer 3
Junos OS	Yes
Maximum VLANs	4093
DRAM	512 MB
Flash Memory	256 MB
Ports	24 or 48
Uplink Ports	4 SFP
Power Supply	AC or DC
MAC Address Table Size	16, 000 entries
Dimensions (W x D x H)	17.4 x 14.4 x 1.7 inches
Weight	12.3 lb (5.6 kg)
Operating Temperature	0°C to 40°C
Operating Humidity	10% to 85% (non-condensing)