CHAPTER 28
Electrical Safety Guidelines and Warnings
•
General Electrical Safety Guidelines and Warnings on page 267
•
Action to Take After an Electrical Accident on page 268
•
Prevention of Electrostatic Discharge Damage on page 269
•
AC Power Electrical Safety Guidelines on page 270
•
AC Power Disconnection Warning on page 271
•
DC Power Electrical Safety Guidelines for Switches on page 272
•
DC Power Disconnection Warning on page 275
•
DC Power Grounding Requirements and Warning on page 276
•
DC Power Wiring Sequence Warning on page 277
•
DC Power Wiring Terminations Warning on page 279
•
Multiple Power Supplies Disconnection Warning on page 280
•
TN Power Warning on page 280
General Electrical Safety Guidelines and Warnings
WARNING: Certain ports on the device are designed for use as intrabuilding
(within-the-building) interfaces only (Type 2 or Type 4 ports as described in
GR-1089-CORE) and require isolation from the exposed outside plant (OSP)
cabling. To comply with NEBS requirements and protect against lightning
surges and commercial power disturbances, the intrabuilding ports must not
be metallically connected to interfaces that connect to the OSP or its wiring.
The intrabuilding ports on the device are suitable for connection to
intrabuilding or unexposed wiring or cabling only. The addition of primary
protectors is not sufficient protection for connecting these interfaces
metallically to OSP wiring.
CAUTION: Before removing or installing components of a device, attach an
electrostatic discharge (ESD) grounding strap to an ESD point and place the
other end of the straparound your bare wrist. Failure to use an ESD grounding
strap could result in damage to the device.
267Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
