Name: Juniper EX3200
Brand: Juniper
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Figure 50: Installing a Power Supply in an EX3200 Switch

NOTE: The power supply must be connected to a dedicated power source

outlet.

NOTE: If you have a Juniper J-Care service contract, register any addition,

change, or upgrade of hardware components at

https://www.juniper.net/customers/support/tools/updateinstallbase/ . Failure

to do so can result in significant delays if you need replacement parts. This

note does not apply if you replace existing components with the same type

of component.

Documentation

Removing a Power Supply from an EX3200 Switch on page 192•

• Installing and Removing EX3200 Switch Hardware Components on page 152

• Power Supply in EX3200 Switches on page 29

• Field-Replaceable Units in EX3200 Switches on page 8

• AC Power Cord Specifications for EX3200 Switches on page 70

• Rear Panel of an EX3200 Switch on page 10

Removing a Power Supply from an EX3200 Switch

The power supply in an EX4200 switch is a hot-removable and hot-insertable

field-replaceable unit (FRU) located on the rear panel of the switch: You can remove

and replace it without powering off the switch or disrupting switch functions.

Ensure that you have the following parts and tools available:

•

Phillips (+) screwdriver, number 2

•

An antistatic bag or an antistatic mat

EX3200 Switch Hardware Guide

Other manuals for Juniper EX3200

Questions and Answers:

Need help?

Do you have a question about the Juniper EX3200 and is the answer not in the manual?

General