Juniper EX3200 Hardware Guide

Table 11: Status LED on Network Ports (continued)
State and DescriptionLCD IndicatorLED
The speed indicators for network ports on the SFP+ and SFP+
MACsec uplink module are:
•
Green—The speed of the transceiver installed in the port is the
same as the speed at which the uplink module port is configured
to operate.
•
Unlit—The speed of the transceiver installed in the port is not
the same as the speed at which the uplink module port is
configured to operate.
The speed of the XFP uplink module ports is always 10 Gbps, which
is also the speed of XFP transceivers, therefore, this LED is always
green on an XFP uplink module..
Related
Documentation
• Front Panel of an EX3200 Switch on page 9
• Uplink Modules in EX3200 Switches on page 15
• LCD Panel in EX3200 Switches on page 11
25Copyright © 2016, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions

Juniper EX3200 Specifications

General

Model	EX3200
Rack Units	1U
Layer Support	Layer 2 and Layer 3
Junos OS	Yes
Maximum VLANs	4093
DRAM	512 MB
Flash Memory	256 MB
Ports	24 or 48
Uplink Ports	4 SFP
Power Supply	AC or DC
MAC Address Table Size	16, 000 entries
Dimensions (W x D x H)	17.4 x 14.4 x 1.7 inches
Weight	12.3 lb (5.6 kg)
Operating Temperature	0°C to 40°C
Operating Humidity	10% to 85% (non-condensing)