:VOLTage:[DC]
:NPLCycles <n>
:NPLCycles?
:RANGe
[:UPPer] <n>
[:UPPer]?
:AUTO <b>
:AUTO?
:REFerence <n>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
:DIGits <n>
:DIGits?
:AVERage
:TCONtrol <name>
:TCONtrol?
:COUNt <n>
:COUNt?
:STATe <b>
:STATe?
:TERMinal <name>
:TERMinal?
:RATio <b>
:RATio?
:STERminals
:RANGe
[:UPPer] <NRf>
[:UPPer]?
:AUTO <b>
:AUTO?
:REFerence <NRf>
:STATe <b>
:STATe?
:ACQuire
:REFerence?
Path to configure DC voltage:
Set integration rate (line cycles; 0.01 to 10).
Query line cycle integration rate.
Path to configure measurement range:
Select range (0 to 1010).
Query range.
Enable or disable auto range.
Query auto range.
Specify reference (-1010 to +1010).
Enable or disable reference.
Query state of reference (0 or 1).
Use input signal as reference.
Query reference value.
Specify measurement resolution (4 to 8).
Query resolution.
Path to configure and control the filter.
Select filter type: (MOVing or REPeat).
Query filter type.
Specify filter count (1 to 100).
Query filter count.
Enable or disable filter.
Query state of digital filter.
Select terminal type: (NORMal or SENSe).
Query terminal type.
Takes ratio of input/sense terminal.
Query ratio state.
Path to sense terminal commands.
Path to configure measurement range:
Specify STERminal range (0 to 10.1).
Query range.
Enable or disable sense terminal autorange.
Query sense terminal autorange.
Specify reference (REL) value for sense terminals
(-10.1 to 10.1).
Enable or disable sense terminal reference (REL).
Query sense terminal reference (REL) state.
Use and save sense terminal input as new reference.
Query sense terminal reference (REL) value.
1
1000
ON
0
OFF
8
(Note)
10
OFF
NORMal
1.000000
ON
0
OFF
√
√
√
√
√
√
√
√
√
√
√
√
Table 5-6 (cont.)
SENSe command summary
Command Description
Default
parameter
SCPI
SCPI Command Reference 5-13
To Next Page
Loading...
Need help?
General
