Keithley 2010

List of Tables
2 Basic Measurements
Table 2-1 Fuse ratings ............................................................................ 2-9
Table 2-2 Factory defaults .................................................................... 2-13
3 Measurement Options
Table 3-1 Rate settings for the measurement functions ......................... 3-7
Table 3-2 Auto delay settings ................................................................ 3-9
Table 3-3 Bus commands parameters for stepping and
scanning counters ........................................................... 3-25
4 Remote Operation
Table 4-1 Language support ................................................................... 4-3
Table 4-2 RS-232 connector pinout ....................................................... 4-7
Table 4-3 General bus commands and associated statements .............. 4-12
Table 4-4 IEEE-488.2 common commands and queries ...................... 4-34
5 SCPI Command Reference
Table 5-1 Signal oriented measurement command summary ................ 5-2
Table 5-2 CALCulate command summary ............................................ 5-7
Table 5-3 DISPlay command summary ................................................. 5-8
Table 5-4 FORMat command summary ................................................. 5-9
Table 5-5 ROUTe command summary .................................................. 5-9
Table 5-6 SENSe command summary ................................................. 5-10
Table 5-7 STATus command summary ............................................... 5-17
Table 5-8 SYSTem command summary .............................................. 5-18
Table 5-9 TRACe command summary ................................................ 5-18
Table 5-10 Trigger command summary ................................................. 5-19
Table 5-11 UNIT command summary ................................................... 5-20
B Status and Error Messages
Table B-1 Status and error messages ..................................................... B-2
D Models 196/199 Commands
Table D-1 Models 196/199 device-dependent command summary ....... D-2
Table D-2 Range selection for ohms function ....................................... D-6